I was planning with simbrief a flight from LECO to LEAS, and when I picked low enroute charts in the navigraph charts website, they didn’t change and remain with upper airways. For example It didn’t show R42 that is showed in simbrief and in the official Spanish AIP, instead is showing the UM190 (Upper airway)
Route: ROXER R42 MASIP
Is it possible to fix them?
This is not an error. It is how the airway network looks in Spain. There have been a few topics on this in the past, for example:
Thank you for your reply.
Ok, I readed the post you linked and I know in Spain the airways are overlapping. But since the routes starting with RXXX are low and the starting with UMXXX are upper…
Is not possible to filter that in the map? Just because when I’m planning the route, I’m unable to see which are the lower routes (its names), just because the upper are shown over (finally I have to discover its name going to AIP or trusting simbrief.
Finally I’ve discovered that clicking in the airway when low enroute is selected, shows the information and the name of the lower airway.
But it would nice to remove the overlap of the upper airways in the map.