NAT Routes on High IFR to be toggled on/off

Wishlist
1

Is there a way that an on/off switch can be implemented to not show the NAT routes on high IFR, so that it doesn’t over load the map, if you are flying within the Maritime area? Navigating in the area, it is hard to select H-IFR routes when the NAT’s are consuming the entire screen.

image
image864×1147 312 KB

2

Hello! Thank you for creating this topic!

It’s currently not possible to turn off only these routes, but they can be toggled with the “Airways” category. I assume you tried this already and want to control these routes individually?

Kind Regards,
Malte

3

Yes, I was hoping they could be toggled, leaving the standard H-IFR routes. Just seems too over whelming, trying to figure out where the regular H-IFR routes are. I’ll just have to use the L-IFR instead for the travelling in the Maritimes/Labrador/Newfoundland area.

Just thought that operationally, the H-IFR routes are being treated separate from the NAT Oceanic routes and controlled by two separate Centres, that they would be toggled separately.

H-IFR - Gander Centre
NAT - Gander Oceanic

Thanks for the reply.

1 Like
4

Thanks for the follow-up! I see what you mean, thanks again for opening this wishlist topic!