Airac cycle 2506 rev 1 EDKB missing frequencies

[AndyMp425]

example EDKB Bonn-Hangelar
navigraph charts shows 135.155

in sim atc only offers fss 122.900 (both msfs2020 and msfs2024)

so then I hear all traffic even from other airfields and atc gets spammed

when uninstalling navigraph cycle 2506 through navigraph hub, frequencies go back to normal, atc offers right frequency, 135.155
happens also at other untowered airfields

[AndyMp425]

I have the same problem,with another airport. Not to say many. With the latest airac cycle, all untowered airports default to 122.900… in msfs2020 and 2024. navigraph charts shows 135.25 but in sim is only 122.900. so I hear all the traffic from all airports around me… there is somethign wrong with the navdata.because when I remove airac cycle through navigraph hub, all frequencies are back to normal

[NAVData]

I have moved your posting. Please avoid hijacking other posts in the future.

Thank you very much
Richard

[NAVData]

Hi again,
Thanks for your report. Let me check the frequency at EDKB. Please confirm that you are not using a 3rd party scenery for this airport.

Thank you
Richard

[NAVData]

Hi again,
I have checked the frequencies of your example EDKB, but we don´t have 122.900 as a frequency in our data. I have also checked this in the MSFS2024, and I see the correct frequencies:

So, it must be any other issue on your system. Do you have any 3rd party scenery installed, especially for EDKB? It could also be a 3rd party scenery issue because the frequency does not exist in our data …

Have you tried to set the priority according to our FAQ?

FAQ - Correct loading order in MSFS2024 with 3rd party sceneries

When you identify any issues with missing or wrong/outdated terminal procedures, frequencies, or any other nav facilities on an installed 3rd party scenery, try following: Backup your content.xml file first Open your content.xml file via any text editor Look for: communityfs24-navigraph-nav-jepp Add priority="999" (plus 999) save the file - be sure that you save the file as a UTF8 file (NOT! as a UTF8-BOM file) You can also copy & replace these two lines instead of adding the attribute …

Cheers,
Richard

[AndyMp425]

see, I applied the priority in content.xml, still I get this:
in world map:

when spawned at EDKB:

Yes I am using 3rd party scenery.I tried with the default scenery but same. 122.900 seems to be unicom standard in msfs20/24 which might be realistic in remote US regions with low to no traffic but not in central europe with its hundreds of active airfields… But I dont think it was like that until the su2 update. If I turn on com1 I can hear all the traffic from all airfields. It wasnt like that before. Before I tuned into 135.155 and only heard the traffic tuned to the same frequency at EDKB, before tuning to center after takeoff. This is another fail from asobo, nothing I can do.I reinstalled the entire sim, navigraph, to no avail. It seems its just the way it is now in MSFS

[AndyMp425]

another example:
spawn at EDLT
only 122.900 available