Some airports cannot be entered in airac cycle 2509 rev.2 (e.g., zuuu, zppp)

[dyy001]

after updating the 2509 data for MSFS 2024 , the aircraft with the built-in G1000 avionics in the game (Cessna172 DA62) cannot display the airport codes ZUUU and ZPPP when entering the route (these are the two I have found so far). However, the input function works normally after removing the Navigraph data.

[NAVData]

Hi,
Sorry, not reproducible

Here from the MSFS2024 1.5.27.0, stock scenery and AIRAC 2509 rev. 2 installed:

Entered ZPPP:

Entered ZUUU:

Possible and 3rd party scenery issue, which is not entirely SU3 compatible.

Cheers,
Richard

[dyy001]

I just went and removed the third-party airports for zuuu and zppp, but I still can’t enter them.

[NAVData]

Hi,
Please try this:

FAQ - MSFS2024 (SU3 and above) - airport, procedure, waypoint, 3rd party & flightplan import issues

There is a new loading order logic since SU3; therefore, it is essential to reset your content.xml file when, for example: You miss airports. You miss procedures. You miss waypoints. Legs are missing from the nav devices. There are third-party scenery issues. There are flight plan import issues. … This file will be automatically recreated at the next simulation start. You will find the content.xml file in the following locations (Note, the location has changed since SU3 - it´s now in a sub-f…

It is hard to say what the reason is due to the lack of information from your side, but as you see, when all is set correctly, all packages are fully SU3 compatible—both airports are selectable without any issue.

Cheers,
Richard