Morning After update this morning seem to be CTD when setting up destination airport arrival. Does not occur if I remove Navigraph. Cheers

Hi, fixed with the new upcoming revision 4, which will be released during the day (saturday). Thanks for your patience and your help to identify this issue. Thank you very much. I have load your flightplan now - no CTD or similar else :wink: [image] Cheers, Richard

Fair, however I have removed all addons only navigraph present and it still crashes when I try to load destination approach, whether on the ground air where ever. Once I remove Navigraph all works as it should. So I don’t entirely think its me only!

Also CTD when setting up a IFR FP in MSFS plane menu. This may be airport selective. Its crashing when I select the RNAV 25 at CAU4.

Hi…, With MSFS 1.11.7 with Navigraph AIRAC 2013 rev. 3 version I ran CAU4 RNAV 25 without problems? [image] Cheers Ian

After further testing I isolated it the the CAU4 addon airport, which did work Yesterday before the update and the revised addition of Navigraph. Without the airport installed it works.

Hi again … as I wrote before, due the lack of information we can give you only a general answer and this answer is, it´s working. I have tested it again with 1.11.7. - no CTD - not in the Steam, nor in the Marketplace version. Possible, someone outside of Navigraph can use this airport and the RNAV…

Again I will say download the add-on airport for CAU4. This was working with Navigraph before, is not now! This leads me to believe that other failures may occur with addon airports! So something did change either way. As beta testers we suppose inform you …No?

Hello everyone on the Forum. I get very similar issue. Since I have updated to 1.11.7 once I try load a flight plan I get CTD. It happens only with Navigraph add-on. I have the latest version of Beta and AIRAC rev. 3.

Same on me this morning. Latest Navigraph Beta on board and the latest MSFS version. If I select the FP I get an CTD

Hi … from where are the FP? Can you upload the FP here that we can try to reproduce it? And can you confirm, that you are using “Navigraph Navdata client beta 16 or 17” also? Thank you, Richard

Hi, I always use a FP from two sources: SIMBrief (exported as .pln) or LNM. A CTD concerns both. Yes, I can confirm using Beta 17. I cannot send a FP file cause a 7z is not accepted. I tried load the FP from LOWI (ADIL2J)to LSZH (NEGR1A)

Navigraph

Hotfix 1.11.7 CTD

Navigation Data General MSFS Data

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled