prior cycles manually install into ProSim737 v2.31 along with Prepar3d v4. Cycle 2104 stops and says unable to remove prior cycle.
Don Hodges
Hi Don,
please can you post a screenshot of this message from the manual installer? I have never seen this nor is this message include in the setup scripts. We don"t remove/delete anything - we only add or replace the files.
Therefore, make a screenshot please and load it up here. Thank you!
Cheers
Richard
Hi Don,
thank you … ok, you have any right issues on this folder and/or some files are still open - therefore the “access is denied”. That´s no message from the installer, it´s a message from your system, which is triggered by the installer.
When you remove the “backup”-flag in the setup-screen before, will the installer install all files than without any “access is denied”?
Cheers
Richard
thank you, that resolved the issue & cycle 2104 installed into ProSim737 … Don
This topic was automatically closed 2 days after the last reply. New replies are no longer allowed.