CTD at Chicago area airports

I’ve tried loading in without any addons loaded other than FSHUD and Navigraph Base. If I remove the Navigraph data folders from the community folder, and launch with only FSHUD loaded I do not have a CTD. If I load with the Navigraph data folders in the community folder, but not FSHUD, I also do not have a crash in that scenario. If I disconnect my navigraph subscription so that FSHUD uses its default AIRAC cycle, I do not crash. I tried the Follow Airports with FSHUD loaded and Navigraph Data in the folder:

|Airport | Result|
| KORD | CTD |
| KMDW | CTD |
| KPWK | CTD |
| KRFD | CTD |
| KSPI | No Crash |
| KMKE | No Crash|

Any suggestions on what can be done to fix this issue?

Thank you!

Should add this is MSFS 2020, I downloaded Say Intentions to see what would happen there, and I did not get a crash. So could the issue be in my FSHUD navigraph data, and if so what can be done to fix that?

Hi,
We don’t offer directly the data for FSHud. We offer the LittleNavMap data, and FSHub converts it in their format and offers it directly to you. We have no influence on that.

I hope that helps
Richard

It does, could the issue be in their conversion? I have been trying to work with them too on finding a solution too. However, they haven’t been able to recreate the issue, which makes troubleshooting it pretty much impossible.

I have the same issues with FSHud. They as I feel have no bigger interest in finding the route of the issue. But I moved on with PSXT wich suited my needs in my simulator better.

This topic was automatically closed 7 days after the last reply. New replies are no longer allowed.