I can’t get it to register powered on climber unless im just doing something wrong. This time I completed near 360 turns in both directions, and the lesson review altitude profile shows me ascending for the entire of both turns, probably close to 1500 to 2000 feet, but it says I completed none. I have tried this about 5 times now and it won’t register them. Anyone else seen this? Not sure this links or not, but this is the latest flight
Thanks for reporting, I have forwarded this do our developers and will get back to you asap.
Hi!
I have checked this flight and it appears the two latter turns were fluctuating a lot on vertical speed. Climbs were interupted by several short periods of level flight. Currently our algorithm detects turn type based your vertical speed, and here it was detected as level flight segments. However, you should be able to see the first left climbing turn, which was stable in positive vertical speed. Can you make sure that you are seeing no detections at all? If so, I will continue to investigate why this turn failed to detect.
So we have concluded our investigation. It was determined that your throttle was not at 90% or more, in fact it was recorded at 89%. If the turns were made when the throttle is at <90%, they are not recorded and as such, that section will be failed.
I would recommend you check your throttle axis can go to 100%. If you are at all in doubt about that, rebind the throttle axis from scratch.
Awesome! Thanks so much. I’m using a sliding potentiometer with Mobiflite on my flight panel, I will check the readouts. Appreciate the quick response!